Newly Converted Peugeot Boxer 2 Birth

Full conversion with no expense spared

Fully insulated
Ceiling has 5mm Closed cell foam insulation/deadening followed by 25mm celotex followed by another full layer of closed cell

Walls have closed cell foam followed by 50mm celotex then treated 25mm batton to frame the walls with a further 25mm celotex in between the batons

Floor has closed cell foam base then 25mm batton with 25mm celotex in between the base board is 12mm finished with sun bleached oak amtico flooring

Remaining voids and cavities are filled and insulated with recycled plastic loft insulation

Living area is a very comfortable custom made cushions which turns to a full size double bed with reading lights at ideal reaching height
Storage units above offer vast amount of locker space for bedding and clothing

The kitchen area had a twin gas stove a large sink with mixer tap and plenty of storage below with shelving

The toilet shower area is built around a thetford cassette toilet / shower tray unit with a mixer shower bar with high pressure

The water system is run via a Surflow pump and accumulator to ensure water pressure

The electrical system is a CBE PC210 which gives inside and outside temperature readings, battery levels and water tank capacities, the electrical system also includes a victron DC to DC split charger a Victron solar controller all running alongside 2 x 110amp leisure batteries, these are also chargeable from a 240v hook up connection on the side of the van, this hook up also runs 2 x double 240 plug sockets at the kitchen area

The heating and boiler system is a Truma 4E Combi with is fed from an underslug 16L LPG tank with a level readout based inside of the vehicle, this unit is also fed by 240v mains input for when electric hook up is available
The boiler has a water capacity of 10L so once it has reached temperature then 10L of hot water is achieved
There are 4 hot air outlets 3 in the living area and one in the shower room, ensuring the cubical is warm which means that the can double up as a drying room

There is a skylight in the shower and a skylight in the living area with an extractor fan built in

Lighting in the vehicle in 3 led downlight along the Center and plinth light along the bottom both on separate switches

Alongside the LPG tank is both a fresh water tank and a waste water tank both with drain taps along the bottom of the vehicle

Any questions please contact, I will be able to answer all questions in regards to the build

Please see a list below

– Truma Combi 4E Boiler and space heater with iNet Bluetooth connection (Gas & 240v)
– 16L underslung LPG gas tank
– 66L fresh water underslung tank
– 50L waste water underslung tank
– Shurflo water pump with accumulator
– 44L fridge with freezer compartment
– Thetford toilet with removable cassette
– Shower with hot/cold control
– 240v mains hook up with 2 x double plugs
– Living area skylight with extractor fan
– CBE Control system with battery and temperature monitoring
– 175w Victron mono solar panel
– Victron Solar controller
– Victron DC to DC split charger
– 2 x 110amp leisure battery’s
– Adjustable 360° Table
– Gas Hob
– 3m Fiamma awning

Thanks for looking